Linux version 2.4.21-0.13mdkcustom (root@localhost.localdomain) (gcc version 3.2.2 (Mandrake Linux 9.1 3.2.2-3mdk)) #5 Wed Jun 4 15:36:26 CDT 2003 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000dc000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000002ff70000 (usable) BIOS-e820: 000000002ff70000 - 000000002ff7b000 (ACPI data) BIOS-e820: 000000002ff7b000 - 000000002ff80000 (ACPI NVS) BIOS-e820: 000000002ff80000 - 0000000030000000 (reserved) BIOS-e820: 00000000ff800000 - 00000000ffc00000 (reserved) BIOS-e820: 00000000fffffc00 - 0000000100000000 (reserved) 767MB LOWMEM available. ACPI: have wakeup address 0xc0001000 On node 0 totalpages: 196464 zone(0): 4096 pages. zone(1): 192368 pages. zone(2): 0 pages. ACPI: RSDP (v000 TOSCPL ) @ 0x000f6a70 ACPI: RSDT (v001 TOSCPL RSDT 01540.00000) @ 0x2ff74af0 ACPI: FADT (v001 TOSCPL BrkdlePE 01540.00000) @ 0x2ff7af8c ACPI: DSDT (v001 TOSCPL BrkdlePE 01540.00000) @ 0x00000000 ACPI: BIOS passes blacklist Kernel command line: BOOT_IMAGE=linux ro root=301 devfs=mount hdc=ide-scsi ide_setup: hdc=ide-scsi Initializing CPU#0 Detected 2389.903 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 4771.02 BogoMIPS Memory: 774440k/785856k available (1539k kernel code, 11028k reserved, 526k data, 124k init, 0k highmem) Dentry cache hash table entries: 131072 (order: 8, 1048576 bytes) Inode cache hash table entries: 65536 (order: 7, 524288 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 65536 (order: 6, 262144 bytes) Page-cache hash table entries: 262144 (order: 8, 1048576 bytes) CPU: Trace cache: 12K uops, L1 D cache: 8K CPU: L2 cache: 512K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: bfebf9ff 00000000 00000000 00000000 CPU: Common caps: bfebf9ff 00000000 00000000 00000000 CPU: Intel(R) Pentium(R) 4 CPU 2.40GHz stepping 07 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel ACPI: Subsystem revision 20030122 PCI: PCI BIOS revision 2.10 entry at 0xfd994, last bus=2 PCI: Using configuration type 1 ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: System [ACPI] (supports S0 S3 S4 S5) ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) PCI: Ignoring BAR0-3 of IDE controller 00:1f.1 Transparent bridge - Intel Corp. 82801BA/CA/DB PCI Bridge ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.AGP_._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.HUB_._PRT] ACPI: PCI Interrupt Link [LNKA] (IRQs *10) ACPI: PCI Interrupt Link [LNKB] (IRQs *10) ACPI: PCI Interrupt Link [LNKC] (IRQs 5, enabled at IRQ 9) ACPI: PCI Interrupt Link [LNKD] (IRQs 5, enabled at IRQ 9) ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 7 10 11 12 14 15, disabled) ACPI: PCI Interrupt Link [LNKF] (IRQs 3 4 5 7 10 11 12 14 15, disabled) ACPI: PCI Interrupt Link [LNKG] (IRQs 3 4 5 7 10 11 12 14 15, disabled) ACPI: PCI Interrupt Link [LNKH] (IRQs 5, enabled at IRQ 9) ACPI: Embedded Controller [EC0] (gpe 28) PCI: Probing PCI hardware ACPI: PCI Interrupt Link [LNKE] enabled at IRQ 11 ACPI: PCI Interrupt Link [LNKF] enabled at IRQ 5 ACPI: PCI Interrupt Link [LNKG] enabled at IRQ 11 PCI: Using ACPI for IRQ routing PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off' isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16) apm: overridden by ACPI. Starting kswapd VFS: Disk quotas vdquot_6.5.1 Journalled Block Device driver loaded devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 vesafb: framebuffer at 0xf0000000, mapped to 0xf080c000, size 32768k vesafb: mode is 800x600x16, linelength=1600, pages=2 vesafb: protected mode interface info at c000:f820 vesafb: scrolling: redraw vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 100x37 fb0: VESA VGA frame buffer device pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled RAMDISK driver initialized: 16 RAM disks of 32000K size 1024 blocksize 8139too Fast Ethernet driver 0.9.26 eth0: RealTek RTL8139 Fast Ethernet at 0xf280d800, 00:02:3f:7e:b5:34, IRQ 10 eth0: Identified 8139 chip type 'RTL-8139C' Uniform Multi-Platform E-IDE driver Revision: 7.00beta-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH4: IDE controller at PCI slot 00:1f.1 PCI: Enabling device 00:1f.1 (0005 -> 0007) ICH4: chipset revision 2 ICH4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1860-0x1867, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x1868-0x186f, BIOS settings: hdc:DMA, hdd:pio hda: TOSHIBA MK4018GAS, ATA DISK drive blk: queue c0350140, I/O limit 4095Mb (mask 0xffffffff) hdc: UJDA740 DVD/CDRW, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: host protected area => 1 hda: 78140160 sectors (40008 MB), CHS=4864/255/63, UDMA(100) Partition check: /dev/ide/host0/bus0/target0/lun0: p1 p2 < p5 p6 > usb.c: registered new driver hub NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 8192 buckets, 64Kbytes TCP: Hash tables configured (established 262144 bind 65536) Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. RAMDISK: Compressed image found at block 0 Freeing initrd memory: 105k freed VFS: Mounted root (ext2 filesystem). Mounted devfs on /dev kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. Mounted devfs on /dev Freeing unused kernel memory: 124k freed Real Time Clock Driver v1.10e EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal Adding Swap: 506008k swap-space (priority -1) SCSI subsystem driver Revision: 1.00 scsi0 : SCSI host adapter emulation for IDE ATAPI devices Vendor: MATSHITA Model: UJDA740 DVD/CDRW Rev: 1.00 Type: CD-ROM ANSI SCSI revision: 02 kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,6), internal journal EXT3-fs: mounted filesystem with ordered data mode. ohci1394: $Rev: 693 $ Ben Collins ohci1394_0: OHCI-1394 1.1 (PCI): IRQ=[10] MMIO=[d2004000-d20047ff] Max Packet=[2048] ieee1394: SelfID completion called outside of bus reset! ieee1394: Host added: Node[00:1023] GUID[00023f2c2d004309] [Linux OHCI-1394]